Features
Power_electronics Features

BEV advancements are driving sales, but vehicle safety and reliability will ensure long-term viability
Innovative power architectures using power modules provide power redundancy and improve overall safety and system performance By Patrick Kowalyk, Automotive FAE,Vicor
More details...
AC/DC power factor correction module offers up to 1,512W
A full brick package developed by TDK-Lambda, the PF1500B-360, is for high voltage distributed power architectures
More details...
Power Electronics Europe News
 
Switching regulator has control input to protect circuits

The 16A point of load (PoL) switching regulator has an industry standard pin-out, high efficiency, wide temperature operation and protection from circuit faults and low cost.

It operates from an 8.3 to 14V DC input, producing a single tightly regulated output at up to 16A. The output can be adjusted over 0.7525V to 5.0V with a simple trim, says the company. Efficiency is up to  95% with low noise operation and tight line/load regulation. Protection against short circuit and over current faults is standard.

The regulator’s control input allows the unit to be turned on/off remotely. (The regulator is available with positive or negative logic for this feature.)

Mean time between failure (MTBF) is greater than one Mhours (per MIL HDBK 217F).

The miniature, unpotted (open board) regulator measures 33 x 13.5 x 8.3mm and is specified for operation over the industrial operating temperature range of -40 to 85°C with no heat sinking required. Cooling is by free-air convection.

  

 

 

 



View PDF
 
Go Back   
Newsletter sign up

Sponsors