Features

MHz switching frequency-based devices enable miniaturization of the DC-DC converter and EMI filters
Achieving EMI conducted emission compliance for automobiles with a single stage filter. By Nicola Rosano, Sr. Strategic FA/System Engineer at Vicor
More details...
AC/DC power factor correction module offers up to 1,512W
A full brick package developed by TDK-Lambda, the PF1500B-360, is for high voltage distributed power architectures
More details...
A full brick package developed by TDK-Lambda, the PF1500B-360, is for high voltage distributed power architectures
More details...
Power Electronics Europe News
Two data lane ReDriver supports MIPI D-PHY 1.2 protocols
_PI2MEQX2503.jpg)
Optimum electrical performance is enabled via a CSI2 source to a DSI sink, adds the company.
The 120mW active mode power consumption is more power efficient compared to a ReTimer, while in low power (5mW), ultra-low power (2mW) and shutdown (0.2mW) modes further help to extend battery life. There are also features like programmable receiver equalisation, output swing, and pre-emphasis to compensate for channel loss with low latency over longer-length traces while minimising power consumption.
The ReDriver has an operating temperature range of -40°C to 85°C for industrial applications and is in a small X1QFN-24 (XEA24) package measuring 2.0 x 4.0mm.
View PDF
| Home / News / Features / Events / Media Data / Issue Archive / Magazine Subscription / Contact Us
| Privacy Policy | Site Map | © Copyright DFA Media
| Web design by Immersive Media
| Privacy Policy | Site Map | © Copyright DFA Media
| Web design by Immersive Media